The Pro-Bore Polisher will improve the speed of your car by reducing friction inside the wheel bore.

• Eliminates plastic debris and minimizes flaws inside the wheel bore
• Polishes the wheel bore to a high shine

The Pro-Bore Polisher cleans and polishes the wheel bore to minimize friction. In addition to the Pro-Bore Polisher,a pipe cleaner (supplied),1 micron plastic polish,a hand drill,and a clamp are required.

Instructions:

Preparation

1. Clamp the hand drill to a work surface using the clamp. Do not use a Dremel-type tool as the RPM is too high.
2. Insert the solid shaft of the Pro-Bore Polisher into the chuck of the drill.
3. Cut a piece of pipe cleaner 1-1/4” long.
4. Slide the pipe cleaner between the two prongs of the tool. Make sure that the pipe cleaner is centered between the prongs.

Caution - Some polish may be thrown when the drill is running,so wear eye protection,old clothes,and cover any sensitive equipment on either side of the pipe cleaner.

Polishing

1. Apply a small amount of polish to the pipe cleaner. Spread the polish onto the entire pipe cleaner surface.
2. Slide a wheel onto the pipe cleaner and over the tool.
3. Hold the wheel and start the drill on a slow to medium speed.
4. Move the wheel back and forth on the tool for 5 to 10 seconds.
5. Slide the wheel off the tool onto the pipe cleaner and polish for an additional 5 seconds.
6. Remove the wheel and stop the drill.

Repeat steps 5 to 10 for the other wheels.

Important - Do not slide the wheel onto the Pro-Bore Polisher while the drill is running.

Clean-Up

1. Wash the wheels in water,using a clean portion of the pipe cleaner to scrub inside the bore.
2. Dry the wheels. A dry portion of pipe cleaner can be used to dry inside the wheel bore .